Installing The Starter Motor; Starting System; Checking The Fuse (E And W Model); Checking The Engine Start Switch - Yamaha F30A Service Manual

– +
ELEC

Installing the starter motor

1. Install the starter motor to the power unit.
2. Connect the wiring harness to the starter
motor, and then fasten the wiring har-
ness.
NOTE:
To connect the wiring harness to the starter
motor, see "Electrical component and wiring
harness routing" (8-1).

Starting system

Checking the fuse (E and W model)

1. Check the fuse for continuity. Replace if
there is no continuity.
NOTE:
For the location of the fuse, see "Electrical
component and wiring harness routing" (8-1).

Checking the engine start switch

1. Disconnect the 10-pin (7-pin) main har-
ness coupler.
2. Measure the input voltage at the 10-pin
(7-pin) main harness coupler (outboard
motor end). Check the fuse and wiring
harness if below specification.
8-13
Electrical system
S6AU8024
È
R B
R
B
È 7-pin main harness model
Engine start switch input voltage
(reference data):
Red (R) – Black (B)
12 V (battery voltage)
3. Set the shift lever or remote control lever
to the N position.
4. Check the engine start switch for continu-
ity at the 10-pin (7-pin) main harness
coupler (tiller handle end or remote con-
trol box end). Check the wiring harness
and neutral switch, or replace the engine
start switch if out of specification.
È
3
4
1
2 5
S67C8032
S67C8069
67C3K11