4. After the 1st 10 hours of operation:
Operate the engine normally.
a
b
È
0
1
2
È Hour
After the test run
1. Check for water in the gear oil.
2. Check for fuel leakage in the cowling.
3. Flush the cooling water passages with
fresh water using the flushing kit and with
the engine running at idle.
CAUTION:
Be sure to supply sufficient water and
water pressure when flushing the cooling
water passages. If sufficient water and
sufficient water pressure are not supplied,
the engine can overheat.
NOTE:
When using the flushing device (flushing
hose joint adapter), flush the cooling water
passages without starting the engine.
Precaution when transporting or
storing the outboard motor
1. When transporting or storing the out-
board motor while removed from a boat,
keep the outboard motor in the attitude
shown or use an outboard motor stand.
67C3K11
c
10
S69J1240
Predelivery check
S67C1048
1-20
1
2
3
4
5
6
7
8
9