Removing The Clamp Bracket; Checking The Hydraulic Tilt Unit; Installing The Clamp Bracket - Yamaha F30A Service Manual

BRKT
4. Remove the bolts 5 and disconnect the
ground leads 6 from the PTT unit 7.
5. Remove the bolts 8, washers 9, bush-
ings 0, and shaft A.
6. Remove the E-clips B, shaft C, and
bushing D.
7. Remove the PTT unit 7, and then
remove the bushings E.
B
C
D
8
9
A
0

Removing the clamp bracket

1. Remove the trim sensor cam 1. (R
model with PTT)
2. Remove the ground lead(s) 2, self-lock-
ing nut 3, bolt 4, and through tube 5,
and then remove the clamp brackets 6.
3. Remove the trim sensor 7. (R model
with PTT)
7-29
Bracket unit
E
E
B
6
0
5
9
8
5
S67C7050
É
3
1
2
7
È D model
É R model with PTT
NOTE:
6
Be sure to remove the ground lead(s) 2
before removing the self-locking nut 3.

Checking the hydraulic tilt unit

1. Check the hydraulic tilt unit. Replace if
there is oil leakage, gas leakage, or dam-
age, or if the rod is bent.

Installing the clamp bracket

1. Install the trim sensor 1 to the swivel
bracket 2. (R model with PTT)
2. Assemble the clamp brackets 3 and
swivel bracket 2, and then install the
through tube 4 from the port side.
6
7
È
2
2
5
4
6
S67C7051
S67C7136
67C3K11