Table of Contents
Advertisement
EXTERNAL CONNECTIONS
ALARM IN
You can connect an alarm switch with a resistance
of 1 kohm or less or a door sensor. Connect pin q
to !5 or !6 (ground) through the switches.
ALARM IN
1
Note: Do not apply a voltage to pin q , !5 or !6 .
ALARM OUT
Approx. 12V is applied to pin w during an alarm
recording.
Notes:
• When you have selected "PULSE" in the "ALARM
OUT" menu in the ALARM display, approx. 12V
pulses will be applied to the output after the
alarm recording ends.
• When you have selected "DURATION" in the
"ALARM OUT" menu in the ALARM display, no
voltage is applied after the alarm recording ends.
• The output impedance is approx. 100 ohm.
TAPE END OUT
Approx. 12V is applied to pin r when the tape
reaches the end.
Notes:
• This does not operate when you have selected
"REW, RE-REC" in the "RECYCLE FUNCTIONS"
menu in the ALARM display or you have selected
"REWIND, STOP IF ALARM" and no alarm
recording has been made.
• The output impedance is approx. 100 ohm.
TAPE END RESET
The TAPE END OUT can be turned off when pin t is
shorted to pin !5 or !6 .
Note: Do not apply a voltage to pin t , !5 or !6 .
GND
WARNING OUT
6 1
5 1
or
When an abnormality has occurred in this VCR,
approx. 5V is output to pin y to warn the user.
TIME ADJUST
When two or more of this VCR model are used,
connect via these terminals. With only one VCR,
specify TIME ADJUST:
items on the CLOCK SET display. Specify TIME
ADJUST: SLAVE (default setting at the factory) for
all other VCRs. Each time "2:00:05" is reached, the
VCR set to MASTER transmits pulses for adjustment
to the VCRs set to SLAVE. When the VCRs set to
SLAVE receive these pulses, their clocks will adjust
to the same time as the clock in the VCR set to
MASTER.
Notes:
• Do not connect any device to pin e , u , !1 , !2 .
• Be sure to set only one VCR to MASTER. If no VCR
is set to MASTER, or two or more VCRs are set to
MASTER, the TIME ADJUST function will not
operate normally.
AVR24TLAX (E) QR34283
MASTER, in [OPTIONS]
8
Advertisement
Table of Contents
