Table of Contents
Advertisement
[REAR]
39
39. AC INLET
40. VIDEO IN
Receives video signal from a video camera or another
VCR.
41. VIDEO OUT
For connection to monitor.
42. EXTERNAL INTERFACE (8 X 2-PIN) JACK
Connect an alarm switch, door sensor, etc.
1
2
3
4
9
0 1
1 1
2 1
3 1
q ALARM IN
w ALARM OUT
e NC
r TAPE END OUT
t TAPE END RESET
y WARNING OUT
u NC
i TIME ADJUST
o CAMERA SW OUT
!0 REC START IN
!1 NC
!2 NC
!3 REMOTE IN
!4 REC CHECK IN
!5 GND
!6 GND
42
5
6 7
8
4 1
5 1
6 1
40
41
43
44
43. AUDIO IN
Accepts an audio signal from a camera, external
sound equipment or another recorder (Line: –8 dBm,
50 kohm, unbalanced).
44. AUDIO OUT
Provides an audio output for a monitor or another
recorder (–9 dBm, 600 ohm, unbalanced).
CONNECTING WIRES
1. Strip off the wire cover by approx. 10mm.
2. Use a screwdriver, etc. to hold the tab, then
insert the wire.
• Push the tab firmly when inserting wire.
3. Release the screwdriver.
• The wire will be fixed.
Note: When disconnecting the wire, use the
screwdriver again to hold the tab, then pull the wire
out.
Tab
Screwdriver
10mm
AVR24TLAX (E) QR34283
Wire
6
Advertisement
Table of Contents
