Dmx Channel Data - KAM LED PARBAR MKIII Instruction Manual

DMX channel data

PLEASE NOTE - the DMX function will only work if CH1 is set to DMX Mode, which is set by adjusting the DMX fader
value below 009 and the DMX Fade function (CH2) is set to light output level above 0% or DMX fader value greater
than 1. Please Locate CH1 position the fader greater than 000 and less than 009 DMX fader value. Locate CH2 fader
and check fade function control is set. Increase to DMX fader value 255 for 100% full on output. Then you will have
control of the DMX functions.
Channel
CH1
CH2 RGB general dimming
CH3 Choose speed
CH4 Red LED intensity adjustment
CH5 Green LED intensity adjustment
CH6 Blue LED intensity adjustment
CH7 Red LED intensity adjustment
CH8 Green LED intensity adjustment
CH9 Blue LED intensity adjustment
CH10 Red LED intensity adjustment
CH11 Green LED intensity adjustment
CH12 Blue LED intensity adjustment
CH13 Red LED intensity adjustment
CH14 Green LED intensity adjustment
CH15 Blue LED intensity adjustment
Function
Mode 01
Mode 02
Mode 03
Mode 04
Mode 05
Mode 06
Mode 07
Mode 08
Mode 09
Mode 10
Mode 11
Mode 12
Mode 13
Mode 14
DMX value
ENABLES USE OF DMX CHANNELS 1-15
000～009
010 – 029
030 – 049
050 – 069
070 – 089
090 – 109
110 – 129
130 – 149
150 – 169
170 – 189
190 – 209
210 – 229
230 – 249
250 – 255
Only works when CH1 is between 000<009
0～255
PLEASE NOTE NO OUTPUT FROM ANY DMX
CHANNELS UNLESS FADE IS ABOVE ZERO.
0～15
16-255
PLEASE NOTE FULL ON NON STROBE IS ZERO
10～255
0～255 Red LED of the 1
0～255 Green of the 1
0～255 Blue LED of the 1
0～255 Red LED of the 2nd par can intensity0%～100%.
0～255 Green LED of the 2nd par can intensity0%～100%.
0～255 Blue LED of the 2nd par can intensity0%～100%.
0～255 Red LED of the 3
0～255 Green LED of the 3
0～255 Blue LED of the 3
0～255 Red LED of the 4th par can intensity0%～100%.
0～255 Green LED of the 4th par can intensity0%～100%.
0～255 Blue LED of the 4th par can intensity0%～100%.
Function
Run program 01 – CH3 >15
Run program 02 – CH3 >15
Run program 03 – CH3 >15
Run program 04 – CH3 >15
Run program 05 – CH3 >15
Run program 06 – CH3 >15
Run program 07 – CH3 >15
Run program 08 – CH3 >15
Run program 09 – CH3 >15
Run program 10 – CH3 >15
Run program 11 – CH3 >15
Run program 12 – CH3 >15
4 Sound patterns
FADER – DIMMER
No strobe
Choose strobe / running speed
Strobe / running speed choosing
par can intensity 0%～100%.
st
par can LED intensity0%～100%.
st
par can intensity0%～100%.
st
par can intensity0%～100%.
rd
par can intensity0%～100%.
rd
par can intensity0%～100%.
rd