General Status - Motorola DCH200 Installation Manual

4 DIAGNOSTICS
You can use the following keys to navigate the diagnostics menus:
•
Press channel ▲, channel ▼, cursor ▲, or cursor ▼ to select d01 through d22.
•
Press cursor ◄, cursor ►, SELECT or ENTER to execute the selected diagnostic.
•
To exit the diagnostic mode, press POWER on the remote control. The set-top
exits the diagnostic mode and powers off.

General Status

This diagnostic displays the error code and description, purchase count, and other
information.
The General Status fields are:
Field
Error
Error Code
E 00
E 01
E 02
E 03
E 04
E 07
E 08
Description
Error codes display on the OSD when an error occurs. If multiple errors occur, the last
recorded error is displayed:
Description Cause
NO ERROR Indicates normal condition
after initialization
NOT The set-top did not receive a
CONNECTED connect message
PWR CYCLE Init Error
DRAM DRAM error
DPSRAM DP-SRAM error
ROM ROM verification failure
RAM Faulty RAM, ROM, EEPROM,
or POST failure (this is a
Remedy
None
Restore out-of-band signal
Send a connect message
The set-top needs a power cycle
to recover
Not used
Not used
Power cycle the set-top; if
repetitive, return for repair
Return the set-top for repair
14