Burner; Cleaning And Maintenance; Cleaning The Glass; Care Of The Coated Parts And Ceramics - Faber VASKA C11 Installation Manual

GB
Shove the sawed off outer pipe into the chimney vent unit through
the rubber ring.
Now position the device with the sawed off inner pipe attached.
Now the flexible stainless steel pipe can be connected to the sawed
off inner pipe of the Direct-vent Built-in Gas Appliance.
Make this connection airtight by securing the stainless steel pipe with
the ring clip.
Place the outer pipe in position and shove it into the flue gas
exhaust outlet of the Direct-vent Built-in Gas Appliance. Secure the
pipe with the clamp.
GB 16

7. CLEANING AND MAINTENANCE

The appliance must be cleaned and checked annually by an
authorized installer. This applies for the Direct-vent system as wel.
Check that:
- the gas supply, combustion chamber and flue gas vent systems are
all airtight;
- the regulator and the thermocouple circuit function properly and
that the burner ignites properly.
Clean (if necessary):
- the pilot system;
- the burner;
- the combustion chamber;
- the flue gas exhaust.

7.1 CLEANING THE GLASS

Depending on the intensity of use, a layer may in time form on the
glass. This layer can be removed with a special glass cleaner or
ceramic cook-top cleaner. Follow the instructions on the package. We
advise you to have the appliance cleaned by an authorised installer.
An improperly working flue and logs in the wrong positions will
cause the glass to become dirtier.

7.2 CARE OF THE COATED PARTS AND CERAMICS

Polish the coated finish with a soft duster. Remove any stains using
a damp cloth or lukewarm water once the fireplace has cooled down.
Never use scouring agents, petrol, paraffin or other solvents to clean
the fireplace.

7.3 CARE OF THE SOAPSTONE

Use soap and water to remove any dirt or grease from the soapstone
(remove the stones from the fireplace first). Minor scratches can be
removed using fine sandpaper (240 grey waterproof ).
GB
GB 17