Warning And Error Display For Thumbnail Operation And Usb Host Mode - Panasonic AJ-HPX3700G Operating Instructions Manual

!"#$%&'())*#+,-.+/012345677899./O9:;<99=>>?@A>BACDEFGDEHIJKL?M

Warning and Error Display for Thumbnail Operation and USB HOST MODE

Item Message
CANNOT ACCESS!
WRITE
PROTECTED!
CARD FULL!
NO CARD!
NO FILE!
CANNOT COPY!
CANNOT DELETE !
UNKNOWN
CONTENTS
FORMAT!
CANNOT FORMAT!
CANNOT REPAIR!
CANNOT RE-
CONNECT!
INVALID VALUE!
UNKNOWN DATA!
Thumbnails
CANNOT REPAIR IN
SELECTION!
NO SD CARD!
NO COPY TO SAME
CARD!
SAME CLIP IS
SELECTED!
USER CLIP NAME
MODIFIED!
TOO MANY CLIPS!
LACK OF REC
CAPACITY!
CANNOT CHANGE!
MISSING CLIP!
CANNOT CHANGE!
Soft
keyboard
CANNOT SET!
INVALID VALUE!
164
Maintenance and Inspections: Warning System
Description
Data cannot be accessed because it is corrupted
or for other reasons.
The P2 or SD card is write protected.
The P2 or SD card is full.
No P2 or SD card is inserted.
The designated file is not found.
Images cannot be copied.
Contents version mismatch prevents deletion.
Warning displayed to indicate contents version
mismatch.
P2 card problem prevents formatting.
Data cannot be repaired since content that
cannot be repaired is selected.
A clip that does not span multiple P2 cards
cannot be reconnected.
Entered data was invalid.
The metadata character code is invalid.
Some of the selected clip could not be repaired.
No SD card is inserted.
A clip cannot be copied to the card storing the
original clip.
The clip cannot be copied because a clip that has
already been copied and the original clip have
been selected.
Characters in the clip name had to be deleted in
adding the counter value.
Too many clips are selected.
There is not enough recording capacity left on the
card.
Any thumbnails that cannot be produced on the
AVC-Intra100 or AVC-Intra50 and displayed in
gray cannot be changed at the text memo
position.
A shot mark will be added to the clips recorded
on multiple P2 cards when all P2 cards are not
inserted yet.
[PERSON] will be entered while the text memo is
not available.
The entered value is incorrect.
Measure
Restore media and clips to normal state before
access.
Insert write-enabled media.
Insert media with sufficient capacity.
Insert compatible media.
Check the file.
Check the conditions for copying.
Match devices and contents version.
Match devices and contents version.
Check P2 card.
Check selected content.
Check selected content.
Enter data in a valid range.
Use UTF-8 for the metadata character code. Use
the viewer to enter correct characters.
Insert an SD card.
Copy the selected clip to a card that does not
contain the original clip.
Confirm the selected clip and release either the
source clip or the destination clip and then
execute the copy operation.
The user clip name plus the counter value can
only contain up to 100 bytes. Characters in the
clip name are automatically deleted when the
total exceeds 100 bytes.
Reduce the number of selected clips.
Insert a card with sufficient recording capacity.
Set SYSTEM MODE according to the clips.
Insert all P2 cards with recorded clips, and
confirm that the incomplete clip indicators
disappear, and then add shot marks.
Enter [TEXT] before entering [PERSON].
Change the value.