Panasonic AJ-HPX3700G Operating Instructions Manual page 161

!"#$%&'())*#+,-.+/012345677899./.9:;<99=>>?@A>BACDEFGDEHIJKL?M
6. Recording Error
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
7. Low Wireless Signal Reception
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
8. Battery Nearly Empty
Display window
indication
WARNING lamp
Tally lamp
Viewfinder
Warning tone
Warning description
Recording/playback
operation
Countermeasures
"00:00:00:11" appears in the time code
display field. Even after recording is
stopped, this display continues to blink
until the next operation is performed.
Blinks 4 times per second while recording
continues.
Blinks 4 times per second while recording
continues.
The "REC WARNING" indicator lights up.
Beeps 4 times per second while recording
continues.
This indicates a failure either in the P2
card recording or the recording circuit.
This is displayed when attempting to
record clips where the total quantity
exceeds the upper limit (1000 pieces) for
a single P2 card.
The recording may stop or continue.
Confirm the recording/playback operation
after turning off the power supply once
and then turning it on again.
If the recording cannot be performed
normally, change the P2 card.
No display.
Blinks 4 times per second (during pause
and recording).
Blinks 4 times per second while recording
continues.
The "WIRELESS-RF" indicator lights up
while recording continues.
Beeps 4 times per second while recording
continues.
This error indicates poor wireless audio
reception conditions.
Continues to operate without receiving
the wireless microphone signal.
Check the microphone power supply and
the reception status of the wireless
receiver.
One of the bars in the battery remaining
indicator starts blinking.
Blinks once per second.
Blinks once per second.
The "BATT" LED blinks.
Beeps 4 times per second.
The battery is about to run out.
Continues to operate.
Replace the battery as required.
9. P2 Card Nearly Full
One of the bars for remaining MEDIA
Display window
indication capacity starts blinking.
Blinks once per second while recording
WARNING lamp
continues.
Blinks once per second while recording
Tally lamp
continues.
The P2 card remaining capacity indicator
Viewfinder
blinks.
Beeps once per second while recording
Warning tone
continues.
The total remaining capacity of all the P2
Warning description
cards is 2 minutes or less.
Recording/playback
Continues to operate.
operation
Replace the cards. If there is an empty
Countermeasures
card slot, insert a new card.
10. P2 Card Error
If the error occurs during recording,
"00:00:00:11" appears in the time code
display field. The indication continues to
Display window
flash after recording is stopped and until
indication
the next operation is performed. There is
no indication if the error occurs during
playback.
If the error occurs during recording, the
lamp flashes 4 times per second for a
WARNING lamp period of about 3 seconds after recording
stops. The lamp does not light if the error
occurs during playback.
If the error occurs during recording, the
lamp flashes 4 times per second for a
Tally lamp period of about 3 seconds after recording
stops. The lamp does not light if the error
occurs during playback.
A flashing "CARD ERR '" appears. In
the actual indication the ' is replaced by
Viewfinder
the slot number of the P2 card that
triggered the error.
If the error occurs during recording, the
tone sounds 4 times per second for a
Warning tone period of about 3 seconds after recording
stops. The tone does not sound if the
error occurs during playback.
An error has occurred while recording
Warning description
data to or playing data from a P2 card.
Recording/playback
Stop recording or playback.
operation
Countermeasures Replace the affected P2 card.
Maintenance and Inspections: Warning System
161