Arctic Cat 2011 425 Service Manual page 60

4. Place the reverse driven bushing (13) onto the shaft;
then install the bearing (14), gear (15), and splined
washer (16). Secure with a snap-ring.
5. Install the reverse dog on the shaft; then place the
shift forks and shift shaft into position.
FI666
 NOTE: The countershaft assembly is now ready to
be installed.
Assembling Crankcase
 NOTE: For ease of assembly, install components on
the right-side crankcase half.
 NOTE: If the output shaft was removed, make sure
that the proper shim is installed.
1. Install the output shaft into the crankcase making
sure the two gears, shim, washer, and nut are in the
FI665A
correct order.
FI664
2. Install and tighten the output shaft flange nut to 59
FI663
ft-lb. Using a punch, peen the nut.
Manual
Table of Contents
Half
MD1199
MD1079
FI662
59