Configuring For Tcp/Ip - Motorola SURFboard SB4100 User Manual

Hide thumbs Also See for SURFboard SB4100:

Table of Contents

SURFboard

Introduction Before You Begin Installation Operation

The SB4100 contains all necessary software.

You don't need to configure the SB4100 but

you must configure your computer for TCP/IP

(software protocol developed for communica-

tion between computers) and check for an IP

address. Your service provider may provide

additional instructions for setting up your

computer.

Configuring for TCP/IP

The following basic instructions are for

Windows 95 or Windows 98. If you are using

a different operating system, refer to that

user guide.

On the Windows Desktop, click Start.

Select Settings and then Control Panel

from the pop-up menus.

Basic Configuration

Double-click the Network icon on the

Control Panel window.

Select the Configuration tab on the

Network window for Windows 95 or 98.

Check to see if TCP/IP has been

installed for the device being used

(Ethernet card or USB). If TCP/IP

appears in the list of network

components, it is installed and

you can proceed to step 10. If it

doesn't appear on the list, continue

with step 6.

Troubleshooting

Table of Contents