Configuring Tcp/Ip; Configuring Tcp/Ip In Windows 98 Second Edition, Or Windows Me - Motorola SBV5121 User Manual

Introduction

Configuring TCP/IP

The SBV5121 VoIP cable modem contains all required software. You do not need to configure the VoIP cable
modem, but you must be sure that your computer is configured for
computers). Perform one of the following:
•

"Configuring TCP/IP in Windows 98 Second Edition, or Windows Me"

•
"Configuring TCP/IP in Windows 2000"
•
"Configuring TCP/IP in Windows XP"
•
Follow the instructions in your Macintosh or UNIX user manual
After configuring TCP/IP, perform one of the following to verify the
•
"Verifying the IP Address in Windows 98 Second Edition, or Windows Me"
•
"Verifying the IP Address in Windows 2000 or Windows XP" on page 31
•
Follow the instructions in your Macintosh or UNIX user manual
Your cable provider may provide additional instructions to set up your computer.
Configuring TCP/IP in Windows 98 Second Edition, or Windows Me
1
On the Windows Desktop, click Start.
2
Select Settings and then Control Panel from the pop-up menus.
3
Double-click the Network icon on the Control Panel window. The Network window is displayed:
4
Select the Configuration tab.
5
Verify that TCP/IP is installed for the adapter that will be used to connect to the VoIP cable modem by looking
for TCP/IP. If found, TCP/IP is installed. Skip to step 10. If TCP/IP is not installed for the adapter, continue
with step 6.
SBV5121 VoIP Cable Modem User Guide
Installation Troubleshooting
TCP/IP
on page 23
on page 26
IP
Glossary
(a protocol for communication between
on page 20
address:
on page 30
License
20