York EVHC 09 DSAAAR Service Manual page 8

Operation of wireless remote control
Remote control
SWING UP AND DOWN BUTTON
Press this button, to set up swing angle,
which circularly changes as below:
This is an universal use remote controller. If
remote controller sends the following three
kinds of status that the swing status of main
unit will be:
When the guide louver start to swing up and
down, if turn off the Swing, the air guide louver
will stop at current position.
128
OFF
which indicates the guide louver swings up
and down between that all five positions.
TIMER ON
TIMER ON BUTTON
Timer On setting: Signal ìONî will blink
and display, signal
numerical section will become the timer
on setting status. During 5 seconds blink,
by pressing
time value of numerical section, every
press of that button, the value will be
increased or decreased 1 minute. Hold
pressing or button, 2 seconds later,
it quickly change, the way of change is:
During the initial 2.5 seconds, ten numbers
change in the one place of minute, then
the one place is constant, ten numbers
change in the tens place of minute at 2.5
seconds speed and carry. During 5s blink,
press the Timer button, the timer setting
succeeds. The Timer On has been set up,
repress the timer On button, the Timer
On will be canceled. Before setting the
Timer, please adjust the Clock to the
current actual time.
TIMER OFF
TIMER OFF BUTTON
Once press this key to enter into
TIMER OFF setup, in which case
the TIMER OFF icon will blink.
The method of setting is the same
as for TIMER ON.
To turn the display panel(indoor
unit) on or off press the light
button on the remote controller.
If the light function is on a
which is be displayed on the LCD
panel of the remote controller
When pressing - and + together the
remote controller will be locked.to
release lock function press - and +
together again.
When unit isoff,
button simultaneously to switch
between and
will conceal, the
or button to adjust the
press MODE and -