Daily Use alternatives. Developed by an audiologist in conjunction with a team of acoustic engineers, Care Tweak Mini can help you hear better in group settings, restaurants, theatres, meetings, and other Do’s and Don’ts challenging listening environments. Troubleshooting Tips...
Tweak Mini into your ear. (all-around sound) (Sleeve or Dome) The rocker switch on the back of Tweak Mini is used during initial set up to See illustrations at right ROCKER SWITCH / UPPER lock in your desired amplifi cation setting. Once your amplifi cation selection is...
Battery Information Preparing for Use Tweak Mini comes with two thin tubes, one for your right ear and one for Tweak Mini uses a 10A zinc air battery. Important — your left ear. “Sleeve” tips are already installed on these tubes, so all you...
If resistance is experienced while closing the battery door, make sure the Insert the battery with the positive “+” side facing up. battery is inserted properly. When the battery door is completely closed, your Tweak Mini is ready for operation. (FIgURe 4) ON –When the battery door is completely closed, your Tweak Mini is on.
Start out in a quiet environment. The fi rst time you turn on Tweak Mini, it will be at the lowest amplifi cation setting. How does it sound? When properly positioned, the tubing will lay close to the head around the front of the ear and into the canal.
From now on, Tweak Mini remembers which amplification setting you picked. Important: Be sure to keep your Tweak Mini dry at all times. See page 17 If you decide later that you want to reset your Tweak Mini to a different for additional tips on caring for your Tweak Mini.
Care The following instructions will assist in extending the life of your Tweak Mini First, remove the tube from the case by twisting the tube connector at least 45° amplifi er. then pulling it off. (FIgURe 10) Cleaning the Exterior Insert the line at the connector end where You should inspect and clean your Tweak Mini every day.
® not being worn.) Extended Storage If it is necessary to store your Tweak Mini amplifiers for an extended clean tube and tip 2 or 3 times per week with the cleaning amount of time, follow the steps below: line provided.
Do’s and Don’ts Troubleshooting Tips (continued) DON’T leave Tweak Mini on the radiator, near a stove, in a sunny No Sound ensure that the battery door is closed. window, in a car or in any other hot place. excessive heat or cold or Not Loud Replace the battery.
Page 11
Amplification Setting 3, consider Amplification Setting 2.) to be sure. (Refer to pages 14-15.) Your Tweak Mini may have a poor battery contact or may not be Try using one of the provided domes. set up properly. email info@TweakHearing.com or call Your Tweak Mini may need to be reset.
Tweak Mini has a serial number located on the underside of the amplifi er. Please record this serial number in the owner information After wearing Tweak Mini for a while, you may decide you want to try a section below.
Page 13
www.TweakHearing.com 1-888-815-3240 A PSAP is a wearable electronic product that is not intended to compensate for impaired hearing, but rather is intended for non-hearing impaired consumers to amplify sounds in the environment for a number of reasons, such as for recreational activities. PSAPs are not intended to diagnose, treat, cure or mitigate disease.
Need help?
Do you have a question about the mini and is the answer not in the manual?
Questions and answers