N Fitting The Jay Precision Back; O Seat Sling - Quickie LXI Owner's Manual

E NG LIS H
To prevent injury: if tension adjustable upholstery is present, loosen straps or remove upholstery
prior to folding or unfolding the chair.
N. FITTING THE JAY® PRECISION BACK
The Jay Precision Back is a tension adjustable back that includes lateral support hardware. It is
designed to follow the contour of the back of the end user and provide beneficial lateral trunk
control.
1. Contour Adjustment
a. To modify the contour of the Jay Precision Back: Pull the Tensioning Straps (A) inward to increase the
tension and lift the tab of the Tension Lock Buckle to release it.
b. To adjust the Jay Precision Back to conform with the user's anatomy, release tension on all straps then
adjust them proceeding from the base of the back upholstery moving up.
c. These adjustments should be done with the user sitting in the chair.
NOTE: If adjustment pushes too far inward it will prevent the chair from folding completely.
d. If adjusted too low, the lateral supports may interfere with the cross brace when folding the chair.
e. These adjustments may be done with the user sitting in the chair.
O. SEAT SLING
33
The seat sling can be adjusted through the use of hook and loop material beneath the seat.
Seat sling also includes a folding strap on the seat to assist in folding the chair.
NOTE– The seat sling folding strap is not intended as a carrying strap.
Adjustment
a. Remove seat rail end caps at the front of the chair (A).
b. Slide the seat sling, plastic retaining rods, and spacers (if present) from the channels in the seat rails.
c. Readjust hook and loop material (B) to obtain the desired tension in the seat sling.
d. Reinsert the seat sling and plastic retaining rods into the channels in the seat rails.
e. Replace the end caps.
930360 Rev. F
WARNING
32 33
22
IX. DEALER SERVICE & ADJUSTMENT
A
32
A
33
B