Anti-Tip Tubes; Height-Adjustable Armrests; Swing-In/Out Hangers And Footrests; M.backrest - Quickie LXI Owner's Manual

E NG LIS H
J. ANTI-TIP TUBES 30
Sunrise recommends Anti-tips for all wheelchairs.
NOTE- Use a torque setting of 115 in.-lbs. when setting up the anti-tip tubes.
1. Height Adjustment of Anti-Tip Receivers
a. Remove anti-tip tubes (A) from anti-tip receivers.
b. Remove the screws and nuts from anti-tip tube receiver (B).
c. Reposition receiver to desired height.
d. Reinsert screw and nuts and tighten.
e. Repeat with second anti-tip tube receiver. Both receiver brackets should be the same height.
f. Press the rear anti-tip snap-button on the anti-tip tube, so that both release pins are drawn inside.
g. Insert it into the anti-tip tube receiver.
h. Turn the anti-tip tube down until release pin is through the receiver mounting hole.
K. HEIGHT ADJUSTABLE ARMREST
1. Adjusting Armrest Receive Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the four bolts on the sides
of the receiver.
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Tighten the four bolts.
2. Adjusting Inner Armpost Fit
a. Two set screws are installed in the outer armpost.
b. Turn the set screws in or out until
the desired fit is achieved.
L. SWING-IN/OUT HANGERS AND FOOTRESTS
(60º, 70º, 70ºV or 90º)
1. Height Adjustment
a. Remove retaining bolt in the frame tube.
b. Slide footrest tubes up or down inside frame tube to desired height.
c. Align predrilled holes in footrest and reinsert bolts.
d. Tighten bolts.
2. Footplate Angle-Adjustment
a. Loosen the retaining bolt in the frame tube.
b. Reposition footplate to desired angle and retighten bolt.
31
M. BACKREST
NOTE: Use a torque setting of 144 in./lbs. to tighten bolts.
1. Height Adjustment
a. Remove bolt (A)which attaches metal upholstery tab to frame tube.
b. The backrest tube (B) telescopes into the frame and is secured by a bolt on the side of the frame.
c. Remove bolt.
d. There are four holes, 1" apart, you may choose from to set the back height.
e. After selecting the proper height, reattach the metal upholstery tab to bolt.
f. Tighten nut and bolt assembly.
IX. DEALER SERVICE & ADJUSTMENT
21
A
B
A
B
30
31
930360 Rev. F