Putting Into Operation; Working Instructions - Bosch BT-EXACT 4 Manual For Installation And Utilisation

BTEXACT_bu_3609929A44_t.fm Seite 12 Montag, 5. September 2005 2:12 14
BT-EXACT/BT-ANGLEEXACT
Screwing System
The screwing system BT-EXACT/BT-ANGLEEXACT
makes possible wireless data transmission of screw-
ing signals by using Bluetooth
Transmitted are OK and NOK signals (screwing in or-
der/not in order) of the industrial battery-operated
screwdrivers of the series BT-EXACT and BT-
ANGLEEXACT to access point EXAConnecT.
Without access point EXAConnecT, screwdrivers of
the series BT-EXACT and BT-ANGLEEXACT cannot
be put into operation: The screwdrivers are locked
when they are delivered and can be unlocked only by
access point EXAConnecT.
Read and follow the operating instructions of ac-
cess point EXAConnecT. Start up access point
EXAConnecT first.

Putting into Operation

When starting the power tool, you should first select
the direction of rotation with the right/left rotation
switch 13 since the power tool starts only when the
right/left rotation switch 13 is not in the middle posi-
tion (switch-on lock).
Setting the Direction of Rotation
13
Right rotation: Press the right/left rotation switch 13
to the left to the stop (Screwing in of
screws).
Left rotation: Press the right/left rotation switch 13
to the right to the stop (Loosening or
unscrewing of screws).
Operate the right/left rotation switch 13 only
when the power tool is at a standstill.
3 609 929 A44 • (05.09) T
Switching on the LED Work Area Illumination
Lamp
®
wireless technology.
The work area lamp 26 makes possible the lighting of
the screwing position for unfavorable light conditions.
The work area lamp 26 is switched on by lightly press-
ing the on/off switch 12. When the on-off switch 12 is
firmly pressed, the power tool is switched on and the
work area lamp 26 continues to light.
Switching On/Off
Switching on: Press the on/off switch 12 to the stop.
Switching off: Release the on/off switch 12.

Working Instructions

Remove the battery from the power tool before
adjustments are made to the tool, accessories
are changed, or the tool is stored. This safety
measure prevents the unintentional switching on of
the power tool.
Place the screwdriver bit onto the nut/screw
only when the screwdriver is switched off. Ro-
tating screwdriver bits can slide off the nut/screw.
English–12
12
26
26 12
Do not look directly into the work area lamp
– your sight can be temporarily degraded!
The tool switches off automatically
when the adjusted torque setting is
reached.
When the on/off switch 12 is released pre-
maturely, the preset torque is not reached.