Intended Use; Noise/Vibration Information; Declaration Of Conformity - Bosch BT-EXACT 4 Manual For Installation And Utilisation

BTEXACT_bu_3609929A44_t.fm Seite 5 Montag, 5. September 2005 2:12 14

Intended Use

The Bosch screwing system BT-EXACT/BT-ANGLE-
EXACT and EXAConnecT is intended for screwing in
and unscrewing screws as well as for tightening and
loosening nuts in the given size and torque range. It
is not intended for documenting torques or angles of
rotation of a screw connection.
Country-specific Instructions
European Community
This tool may be used in all countries of the European
Community. In France, the use of Bluetooth
tolerated. Please inform yourself of the regulations of
the region of use.
North America
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference when the equipment is operated in a com-
mercial environment. This equipment generates, us-
es, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
3 609 929 A44 • (05.09) T

Noise/Vibration Information

Measured sound values determined in accordance
with EN ISO 15744.
Measured vibration values determined in accordance
with EN 28662 and EN ISO 8662.
Typically, the A-weighted sound pressure level of the
product is 70 dB(A).
Measuring inaccuracy K = 3 dB.
The noise level when working can exceed 85 dB(A).
Wear ear protection!
The hand-arm acceleration is typically below 2.5 m/s
Measuring inaccuracy K = 1.2 m/s
®
is only

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
EN 60745, EN 60950-1:2001.12 + A11:2004.04,
EN 50366:2003.05,
EN 55022:1998.09 + A1:2000.10 + A2:2003.01,
EN 61000-6-2:2001.10,
EN 300328 V1.5.1:2004.08 according to the provi-
sions of the directives 89/336/EEC, 99/05/EC,
98/37/EC, 73/23/EC.
operator of the tool must take appropriate measures
to eliminate this interference.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
English–5
2
.
The operation of this tool can
cause radio interference in a
residential area. In this case, the
Dr. Eckerhard Strötgen
Head of Product
Certification
2
.