Paper Width - Epson TM-T83II Technical Reference Manual

Paper sensor to output paper-end signals default
• Paper end sensor enabled, paper near-end sensor enabled (initial setting)
• Disabled
No settings are required.
Error signal output
• Disabled
• Enabled (initial setting)
No settings are required.
Paper near-end sensor
• Disabled (initial setting)
• Enabled
Sounds buzzer on signal output from DK connector pin 2
• Disabled (initial setting)
• Enabled
Sounds buzzer on signal output from DK connector pin 5
• Disabled (initial setting)
• Enabled

Paper width

• 80 mm (initial setting)
• 58 mm
To change the paper width, you need to install the 58-mm width paper guide plate. For
information about how to change the paper width, see
Chapter 2
"Changing the Paper Width" on page
Setup
2
31.
47