Epson TM-T83II Technical Reference Manual page 133

Setting Item
1st page 2nd page
14: Other Settings 2: Buzzer Control
3: Interface
Settings
4: Near-end
Detection
For details about how to set the Software Setting Mode, see
*1: No settings are required.
*2: Do not change the settings.
* Underlined values are the initial settings.
3rd page
Pattern A, Pattern B, Pattern C, Pattern D,
7: Sound Pattern
Pattern E
(Pulse 2)
1 time, No sound
8: Buzzer Fre-
quency(Pulse 2)
No Sound, 1000 ms, 2000 ms, 3000 ms
9: Buzzer Time
(Autocut)
No Sound, Continuous, 1000 ms
10: Buzzer Time
(Offline)
1: Receive Buffer 4 KB, 45 bytes
Capacity
Receive Buffer Full or Offline, Receive Buffer
2: BUSY Condi-
2
Full
tion*
Always disabled, Always enabled
3: Auto Line
1
Feed*
Not BUSY = 256 bytes, Not BUSY = 138 bytes
4: State to cancel
buffer BUSY
Paper End&Near-end Sensor Enabled,
5: Output Paper-
1
Disabled
end Signals*
1
Enabled, Disabled
6: Error Signal*
Disable, Enable
"Software Setting Mode" on page
Appendix
Setting Values
108.
133