Table of Contents
Advertisement
Quick Links
INSTRUCTION MANUAL
Destination Country: United Kingdom, Ireland
It is required by law that all gas appliances are installed by competent persons in accordance with
the LOCAL GAS SAFETY REGULATIONS. Failure to install appliance correctly can lead to
prosecution. It is in your own interests and that of safety to insure that there is compliance with the
IF YOU SMELL GAS
1. TURN OFF THE APPLIANCE AT THE
GAS INLET COCK AND OPEN ALL
DOORS AND WINDOWS.
2. DO NOT OPERATE ANY ELECTRICAL
SWITCHES AND EXTINGUISH ALL
NAKED FLAMES.
3. CONTACT THE LOCAL GAS
AUTHORITY IMMEDIATELY.
M
ONTAGUE
Gas Fired
Salamander
MODELS:
SBE3418 & SBE3618
law.
SHOULD BE READ CAREFULLY AS
THE MANUFACTURER CANNOT BE
DAMAGE TO PROPERTY, PERSONS
PLEASE RETAIN THIS MANUAL
FOR FUTURE REFERENCE.
THE MONTAGUE COMPANY
1830 Stearman Avenue P.O. BOX 4954
HAYWARD,CA 94540-4954
TEL: 510/785-8822 FAX: 510/785-3342
THE FOLLOWING INSTRUCTIONS
HELD RESPONSIBLE FOR ANY
OR ANIMALS CAUSED BY
INCORRECT INSTALLATION OR
OPERATION OF THE APPLIANCE.
Advertisement
Table of Contents
Related Manuals for MONTAGUE SBE3418
Summary of Contents for MONTAGUE SBE3418
- Page 1 Gas Fired Salamander MODELS: SBE3418 & SBE3618 It is required by law that all gas appliances are installed by competent persons in accordance with the LOCAL GAS SAFETY REGULATIONS. Failure to install appliance correctly can lead to prosecution. It is in your own interests and that of safety to insure that there is compliance with the law.
-
Page 2: For Your Safety
IMPORTANT WARNING: Improper installation, adjustment, FOR YOUR SAFETY: alteration, service, or maintenance Do not store or use gasoline or can cause property damage, injury death. Read operating other flammable vapors maintenance instructions liquids in the vicinity of this or any other appliance. thoroughly before installing or servicing this equipment. -
Page 3: Installation
MODEL DESIGNATIONS SBE3418 ………………………………….. 34” (864mm) wide SBE3618 ………………………………….. 36” (914mm) wide GENERAL INFORMATION 1. Check carton or crate for possible damage sustained during transit. Carefully remove unit from carton or crate and again check for damage. - Page 4 2nd FAMILY, GROUP H 3rd FAMILY, GROUP 3P (G20 @ 20 mbar) NATURAL GAS (G31 @ 37 mbar) PROPANE MODEL Per burner / section Per burner / section BTU/HR BTU/HR SBE3418 12.3 42,000 12.3 42,000 SBE3618 12.3 42,000 12.3 42,000...
-
Page 5: General Installation
INSTALLATION GENERAL INSTALLATION SITING The floor on which the range and salamander broiler are to be sited must be capable of adequately supporting the weight of the appliance and any ancillary equipment. Once in position, check that the unit is level, both front to back and side to side. Adjust, if necessary, using the adjusting foot on each leg of range. -
Page 6: Gas Pressure Regulator
GAS PRESSURE REGULATOR THIS BROILER IS DESIGNATED FOR USE WITH A GAS PRESSURE REGULATOR. THE REGULATOR SUPPLIED WITH THIS UNIT MUST BE USED. G20 Natural Gas: This gas pressure regulator is factory adjusted for 6.0” W.C. manifold pressure. The rated inlet pressure to the regulator is 1/2 psig (3.45 kPa). -
Page 7: Installation Procedure
FIG. 1 Range Mounted Installation: Model SBE3418—To be mounted on reinforced high shelf for installation on any 34” wide section of GRIZZLY medium duty range, (models GE26, GEO, GEOO, GE260, GE2616, GE1626, GE2626, and GE60 series) as follows: 1. - Page 8 INSTALLATION INSTALLING CERAMIC RADIANTS 1. Insert ceramic ends at each corner of the burner frame (4 required per burner). 2. Tilt ceramic radiant sideways to clear burner and frame assembly, then lower radiant into position with one flange resting on burner ledge and one flange resting on frame ledge. 3.
-
Page 9: Burner Adjustment
INSTALLATION COMMISSIONING The whole of the gas installation, including the meter, should be inspected, purged, and tested for soundness in accordance with the codes of the country of destination. 1. Ensure that the gas tap is in the “●” position and turn on the main gas supply. Light the pilot in accordance with the User’s Instructions. -
Page 10: Maintenance And Servicing Instructions
MAINTENANCE MAINTENANCE MAINTENANCE AND SERVICING INSTRUCTIONS Regular servicing by a competent person is recommended to ensure the continued safe and efficient performance of the appliance. A list of Authorized Service Agents can be obtained from our Service Department at the following address: FRIALATOR INTERNATIONAL, LTD. -
Page 11: Cleaning Burner Venturi
MAINTENANCE CLEANING BURNER VENTURI 1. Remove top panel. 2. Remove right control panel. 3. Disconnect injector fitting and remove. 4. Loosen thumb screw and slide venturi out of the burner head. 5. Clean the venturi in hot soapy water with a stiff brush. 6. -
Page 12: Renewal Parts
INJECTOR - G31 LP GAS 26186-6 THERMOCOUPLE - M8X1 600mm 26586-1 SLEEVE, COMPRESSION - 1/4" TUBE 26173-4 NUT, COMPRESSION - 1/4" TUBE 26700-7 BURNER 06827-6 VENTURI - SBE3418 06826-8 VENTURI - SBE3618 15827-5 INSULATOR, CERAMIC 11611-4 RADIANT, CERAMIC 02002-8 HANDLE, VALVE 09006-9... - Page 13 A RISK OF EXPOSURE EXISTS IF THE EQUIPMENT IS OPERATED IMPROPERLY. The MONTAGUE COMPANY 1830 Stearman Avenue, P.O. Box 4954 Hayward, CA 94540-4954 Continuous product improvement is The Montague Company Policy, therefore specifications and design are subject to change without notice.
- Page 14 Serial No. _____________________________________________ Model No. _____________________________________________ Change No. ____________________________________________ Name & No. of Part Model No. Change No. Serial No. SBE3418 & SBE3618 Name Plate The Montague Company 1830 Stearman Avenue P.O. Box 4954 Hayward, CA 94540-4954 P/N 26715-5 3/97...
Need help?
Do you have a question about the SBE3418 and is the answer not in the manual?
Questions and answers