Emerson Avocent User Manual page 31

Receiver – Attributes tab
The Attributes tab allows you to change the name, location and description of the receiver. Each
receiver within a system must have a unique name. The Location, Description and Notes fields are
optional, and are used only for your own information.
Receiver – Settings tab
From the Settings tab, you can change various settings for the receiver. The following table
describes the receiver settings.
Receiver Settings Descriptions
Setting
Auto Login
Auto Login Username
Auto Connect
Auto Connect Target
Auto Connect Mode
USB Mode
LCD Backlight
Allowed Access
Video Scaling
Audio Output
Microphone
Keyboard Auto Enumeration
Mouse Auto Enumeration
Description
When enabled, a specified user is automatically
logged into the receiver whenever it is turned on and
physically connected to a switch in the system.
When Auto Login is enabled, this identifies the user
that will be logged in to the receiver.
After a user logs into this receiver (either manually or
because of an auto login), the receiver will
automatically connect a KVM session to a specified
target.
When Auto Connect is enabled, this identifies the
target to which the receiver will be automatically
connected.
When Auto Connect is enabled, this option
determines the mode (Shared or Private) that will be
used for the connection.
Determines what USB devices will be extended from
this receiver to a target.
Determines whether the LCD backlight will be on or
off.
Determines the type of connections this receiver can
establish (Shared, Private or either).
If enabled, the video will be scaled to match the
resolution of the attached monitor if the target is
outputting a different resolution.
Controls whether any audio output from the target is
used to drive the green audio output jack on the
receiver.
Controls whether any signal from the pink
microphone jack on the receiver is sent over the KVM
session to the connected target.
If enabled, the keyboard will be re-enumerated when
connecting to a target.
If enabled, the mouse will be re-enumerated when
connecting to a target.
On-Board Web Interface ..... 25