Table of Contents
Advertisement
2
INSTALLATION continued
2.10 Mechanical Installation - Display
2.10.1 Flush Mounting
Step 1 Leave protective film on LCD in place until completion of installation.
Step 2 Refer to the cut-out dimensions supplied in the package, make a cut-out in the
Step 3 Add a "Non Adhesive" Silicon sealant to interior cut-out perimeter.
Step 4 Place your Nauticomp Glass Bridge Display
Step 5 Install 'Bolt Clips' (x11) into slots located on the rear sides of the Display.
Above Illustration – Orientation of an 'L' shaped 'Bolt Clip' within slot located on the rear of the Display.
Step 6 Thread 'Bolts' (x11) into 'Bolt Clips' leaving enough gap between each 'Bolt' and
Step 7 Insert 'Centering Plates' (x11) into the clearance gap between the Display and
Step 8 Apply 2 Full TURNS to each 'Bolt' to secure Display – Maximum permitted
Above Illustration - Installed 'Bolt', 'L' Shaped Bolt Clip & 'Centering Plate'
CAUTION:
Over tightening bolts WILL cause damage to the display's chassis frame.
mounting location.
the console for 'Centering Plates' to be fitted (refer to Step 7 below).
the console and position under each 'Bolt'. Evenly hand-tighten ALL bolts.
torque loading 20 in/lbs (2Nm).
into the cut-out.
®
'L' Shaped Bolt Clip
Rear of Display
Bolt
'L' Shaped Bolt Clip
Centering Plate
Page 10 of 30
Advertisement
Table of Contents
