Table of Contents
Advertisement
6. Activating the radio alarm system
You can activate the radio alarm system in different ways. The panel gives acoustic messages. Depending on whether a partition or the complete
system has been activated, this message is either "The partition is setting" or "The system is setting"
6.1. Quick activation
Note that this function can
be deactivated to prevent
unauthorised operation of
the equipment. This
function is located in the
Installer menu under System
Options \ User access \
Quick set.
To activate the complete
radio alarm system, just
press the quick set key as
shown.
6.2. User code
If the quick set function is
deactivated, you have to
enter a user code to
activate the equipment. If
the panel has only one
area, just enter your user
code. The area for which
this user code is valid is now
activated. If your user code
is valid for two or more
areas, you now receive a
selection of areas to
activate. Read the sections
"Activating partitions" and
"Part set" (p. 12/13).
6.3. Telecommand
With a telecommand, you
can activate the complete
radio alarm system by
pressing the "fully set"
button. The other buttons
on the telecommand are
for activating a partition or
to activate the radio alarm
system internally. Read the
sections "Activating
partitions" and "Part set"
(p. 12/13).
Do you have zones with the
attribute Force Arm Set, it
may be necessary to
confirm the activation by
pressing the full set button
again.
7
6.4. Proximity tag
You can use the proximity
tag to fully
activate/deactivate the
radio alarm system or a
partition. The proximity tag
is used instead of the entry
of a user code. If you have
a proximity tag and the
authorisation to activate
two or more partitions, you
have to decide which
partition you want to
activate after holding the
proximity tag in front of the
system. Read the sections
"Activating partitions" and
"Part set" (p. 12/13).
6.5. Radio cylinder
You can also use the radio
cylinder to fully activate
the system or a partition. To
activate the radio alarm
panel, first press the button
on the cylinder and then
lock the door. After you
lock the door, the alarm
system is activated.
Advertisement
Table of Contents
