Table of Contents
Advertisement
The items mean:
Function
Meaning
Set Date & Time
Select to enter the date and time of the radio
alarm system.
Edit Outputs
Select to change the times of manual exit. The
manual exit is activated by the first time entered
and deactivated by the second.
Note: You can switch the output on and off from
the User Menu by selecting Outputs On/Off .
If you want to program a telecommand to
control the output, see Telecommands.
Telecommands
Select to redefine the remote control buttons.
You can also program the fourth button function
of the remote control.
Note: If you do not have the telecommand press
"NO TELECOMMAND". The display presents a list
of the registered telecommands and their users.
Select the telecommand you want to edit. Press
to select the button you wish to re-
program.
Once you have selected the button you wish to
reprogram the display gives you the option of
reprogramming the button to either set/unset
some part of the system, or to operate one of
the outputs. Select the option you wish to use
from the display.
Call Downloader
Manually activates the selection of a telephone
number for the remote control (if installed).
Summer/Winter
Select between automatic and manual change
Time
from summer to winter time.
Message Volume
Select the volume of the voice message.
Installer access
Define whether not only the installer code but
also the administrator code must be entered to
activate Installer mode.
About Comms
If you wish to check what type of
telecommunication line your control unit has,
enter this Menu and select About Comms.
Shows information about the analogue line and
the ISDN/GSM/Ethernet/GPRS modules.
If your alarm panel has a ISDN module fitted, the
screen displays
ISDN
If your alarm panel has a GSM module fitted, the
screen displays
GSM IMEI
GSM signal strength
GSM network provider
GSM telephone number.
(Note that some mobile phone service providers
withhold the GSM number from the display.)
If your alarm panel has a Ethernet module fitted,
the screen displays
IP-address
IP-subnetmask
IP-gateway address
MAC-adress
If your alarm panel has a GPRS module fitted, the
screen displays
GSM IMEI
GSM signal strength
GSM network provider (network identification, D1
GSM telephone number.
(Note that some mobile phone service providers
withhold the GSM number from the display.)
Follow the instructions in the display to make settings. The display guides
you through the settings.
32
e.g. 26201
Advertisement
Table of Contents
