Sony Bravia KDL-52Z5500 Operating Instructions Manual page 41

Auto Start-up
Logo Illumination
Language
Product Information
Factory Settings
Analogue Set-up
Programme List
Display
1 Digit Direct
Favourite Set-up
Auto Tuning
Programme Sorting
Programme Labels
Programme Block
You can run the initial set-up that appeared when you first connected the TV, and
select the language and country/area, the region (Australian model only), or tune in
all available channels again.
Even if you have made the settings when you first connected the TV, you may need
to change the settings after moving house, or to search for newly launched
channels.
Lights up and turns off the Sony logo on the front of the TV.
Sets the language displayed on the menu screens.
Displays product information of the TV.
Resets all settings to factory settings except for the "Programme Block" setting,
"Favourite" setting, and programme preset data. After completing this process, the
initial set-up screen is displayed. Completing auto tuning in initial set-up will reset
the settings that are not reset by "Factory Settings." To retain the settings, skip the
"Auto Tuning."
Select "Off" to hide the list of analogue channels from the XMB™
(XrossMediaBar).
When "1 Digit Direct" is set to "On," you can select an analogue channel using one
preset number button (0 – 9) on the remote.
~
• When "1 Digit Direct" is set to "On," you cannot select channel numbers 10 and
above by entering two digits on the remote.
Allows you to set your favourite channels by assigning the desired channel
numbers.
To reset the favourite channels, select "– – –."
Tunes in all the available analogue channels.
You can retune the TV after moving house, or to search for newly launched
channels.
Changes the order of analogue channels stored in the TV.
1
Press F/f to select the channel you want to move to a new position, then press
.
2
Press F/f to select the new position for the channel, then press
Assigns a channel name of your choice, up to five letters or numbers. The name
appears briefly on the screen when you select the channel.
1
Press F/f to select the channel you want to name, then press
2
Press F/f to select the desired letter or number ("_" for a blank space), then
press g.
If you enter a wrong character
Press G/g to select the wrong character. Then, press F/f to select the correct
character.
3
Repeat step 2 until you finish entering the name.
4
Press to exit the labeling procedure.
Blocks an individual channel from being watched.
1
Press F/f to select the channel you want to block, then press
2
Press F/f to select "Block," then press
To watch the channel, select "Allow."
.
.
.
.
(Continued)
41
GB