011608
Fit two protrusion of the pipe holder into the grooves of
the tank cover and then press down the pipe holder.
1
011631
NOTE:
The pipe holder that is excessively lowered than
•
the intended position cannot be installed on the
cord hook with the hook away from the tank cover
as shown in the figure.
1
2
011632
NOTE:
Make sure that the two hooks of the pipe holder are
•
hooked on the tank cover securely.
Connecting a hose
CAUTION:
Never force the hose for bending or stamp it. Never
•
move the cleaner by a hose. Forcing, stamping and
pulling the hose may cause a breakage or
deformation of the hose.
When picking up large wastes such as planer
•
carvings, concrete dusts or similars other than
small wastes, use the 38 mm inner diameter hose
(optional accessory). Using the 28 mm inner
diameter hose may cause a hose stuffing and
damage.
1. Tank cover
2. Hook
2
1. Tank cover
2. Hook
011590
Insert the hose onto the mounting port of the tank and
turn it clockwise until it locks.
Installing polyethylene bag
Cleaner can also be used without polyethylene bag.
However, using polyethylene bag is easier to empty the
tank without letting your hands dirty.
1
011591
Spread the polyethylene bag in the tank. Insert it
between the holder plate and the tank, and pull it to the
hose inlet.
1
011592
Spread the bag around the top of the tank.
Hook up the other side of the bag around the top of the
tank so that the prefilter hook can catch and hold it
securely
NOTE:
A polyethylene bag available on the market can be
•
used. The 0.04 mm or thicker one is recommended.
Too much dust will tear the bag easily, so do not
•
collect the dust more than the half of the bag
capacity.
9
1. Holder plate
2. Tank
2
1. Polyethylene
2
bag
2. Holder plate
3. Tank
3