Table of Contents
Advertisement
ON
OFF
Fig. 15
Fig. 16
Trigger
Fig. 17
Fig. 18
Fig. 19
Fig. 20
OPERATING INSTRUCTIONS
•
Turn on the water supply at the faucet.
•
Make sure the "ON/OFF" switch is in the "OFF" position. The power
switch has international symbols for 'on' and 'off': On (--) Off (O). (Fig.
15)
•
Unwind the power cord completely and plug the GFCI into a grounded
120 volt outlet. Press the 'reset' button on the GFCI box (Fig. 16). The
indicator window should show a red color. This must be done each time
the unit is plugged in.
•
Release the safety lock button on spray gun (Fig. 17) while pointing the
spray gun in a safe direction, away from yourself and others squeeze
the trigger on the spray gun until there is a steady stream of water,
letting the water and air out of the hose.
•
Press the 'ON' button. The motor and pump should now be running and
providing a powerful spray.
OPERATING TIPS AND MAINTENANCE
•
If you hear the motor run intermittently when the trigger is not being
squeezed, that is normal. The pump is priming itself so it is ready to
operate when the trigger is squeezed. Turn off the power washer if not
being used after five minutes.
•
The o-rings on the bayonet end of the adjustable lance and detergent
bottle should be cleaned regularly and lubricated with non-water soluble
grease.
•
The screen inside the clear adapter should be cleaned periodically.
Insert a pen or pencil in small hole at the end of the adapter. The screen
filter will slide out (Fig. 18). Rinse it with clean water, and then place it
back in the adapter.
•
Keep the nozzle cleaning wire, Which is taped to this manual for use
in unclogging the lance nozzle. If you lose the cleaning wire an unbent
paper clip works fine.
Cleaning nozzles
•
A clogged or partially clogged nozzle can cause significant reduction
of water pressure coming out of the nozzle and/or cause the unit to
pulsate while spraying.
•
Turn off the unit
•
Turn off the water supply to the unit
•
Relieve any pressure trapped in the hose by squeezing the trigger 2-3
times, and then lock the spray gun by pushing the lock button from left
to right.
•
Take off the adjustable lance. Rotate the nozzle on the adjustable lance
to the narrow stream setting which opens up the fan blades (Fig. 19).
•
Using the nozzle tip cleaner provided (or an unfolded paper clip), insert
the wire into the nozzle hole and move back and forth until debris is
dislodged (Fig. 20). Back flush water through the nozzles using garden
hose and highest pressure available (either standard water
nozzle or use your thumb over the nozzle to create water
pressure for back flush).
9
en
Hide quick links:
Advertisement
Table of Contents
