Table of Contents
Advertisement
•
IMPORTANT: Store the power washer indoors to prevent the water in the
unit from expanding under freezing conditions. When the water freezes and
expands, your power washer will be damaged and become inoperable. Or,
if storing outdoors, it is recommended you use Pump Saver. Pump Saver
can be purchased on our website: www.arblueclean.com. See details in the
Pump Saver section of this manual.
•
Never use hot water with your power washer. It will overheat and damage
the high pressure pump.
•
Never leave the power washer unattended while it is powered "on".
•
Always turn the water supply "on " before turning the power washer power to
"on". Running the pump dry will cause damage to the internal components.
•
Never use a water supply to your power washer that exceeds 150 psi
maximum.
•
Never disconnect the high pressure hose from the power washer while the
system is pressurized.
•
Never permanently engage the trigger mechanisms on the spray gun.
•
Never operate the power washer unless all components are properly and
securely connected.
•
Never allow the power washer pump to run for more than one minute, after
you have turned off the water supply. This can cause the motor and pump to
overheat and fail.
•
Never use lances or other parts that have not been supplied with your power
washer.
•
Never use an extension power cord since it defeats the effectiveness of the
GFCI and increases the chance of electrocuting the operator.
•
Never spray any electrical outlet with your power washer.
•
Inspect the power cord before using. Do not use it if it is damaged.
Servicing of a Double-Insulated Appliance
In a double-insulated product, two systems of insulation are provided instead of
grounding. Grounding means are not provided for a double-insulated product,
nor should grounding means be added to the product.
Servicing a double-insulated product requires extreme care and knowledge of the
system, and should only be done by qualified service personnel.
Replacement parts for a double-insulated product must be identical to the original
parts. A double-insulated product is marked with the words "Double Insulation" or
"Double Insulated". Product may also be marked with symbol shown here.
5
en
Hide quick links:
Advertisement
Table of Contents
