Wlan Settings; Network Restart; Mac Address; Quick Start Function - Revox S119 User Manual

network receiver
In the case of a manual input, you can
make the following settings:
o IP Address
o
Subnet mask
o
Gateway IP
o
DNS Server 1
o
DNS Server 2
Pressing the OK button moves you from
one input field to the next. After the DNS
Server 2 input has been made, the data
is applied and the system attempts to
establish a connection.
 Factory setting = DHCP

WLAN Settings

Here, you can make the settings for a
WLAN connection. If there is no LAN
connection, any wireless networks that
are found, are displayed in a list. Select
the WLAN network you want to use and
allow the system to guide you through
the connection menu.
If there is already a LAN connection, you
can enter the network name (SSID) and
establish a connection by inputting the
password, the encryption type and the
DHCP definitions.

Network Restart

Carry out a restart after modifying the
network settings (IP/ WLAN) or when
swapping the LAN/WLAN network.
36

MAC Address

Display of the MAC address that has
been uniquely assigned to this S119/
S120.

Quick start function

If the Quickstart function is activated
[on], the network processor is switched
on permanently.
reduces the switch-on phase, as the
connection to the network doesn't have
to be built up again. All other sub-
assemblies, such as the audio signal
processing or the outputs, including the
main transformer are switched off, as
with normal standby mode.
Quickstart mode
requirement, in order to be able to
control the receiver with a network-
based Revox App.
The receiver can be switched on from
standby mode using the Start-up button
on the back of the device (Page 10/11).
This also activates the Quickstart mode
[on], in order to be able to ensure
permanent control through the App,
without the S208 remote control.
Standby consumption goes up < 0.6 watts
to 3.5 watts, if the Quickstart function is
activated.
Configuration
This significantly
[on] is also a