Operation - Start-Up Process - Revox S119 User Manual

network receiver

Operation - Start-up process

Once all the basic settings for the S208
remote control and the S119/S120
network receiver have been made, you
can start with the actual operation.
Switch the S119/S120 on directly by
pressing the hotkey on the remote
control with the name S119 or S120. In
the example on the right, that would be
hotkey A. Alternatively, if no hotkey is
assigned, the network receiver can also
be started with the button combination
(System)  Device Selection [Figure 1]
Several network receivers present
If you are deploying several S119/S120
network receivers, it makes sense to
give them different names, so that they
can be uniquely identified in the device
list or through the hotkey assignment
when calling or starting them.
Now the S208 remote control initiates a
connection query to the corresponding
network receiver. [Figure 2]
Once a wireless connection to the
S119/S120 could be established, but the
network connection
completed, the S208 remote control
shows: [Figure 3]
The S119/S120 always starts up with the
source that had been selected before it
was last switched off.
40
is not yet
[Figure 1]
[Figure 2]
[Figure 3]
Operation