network receiver
Network
All the relevant settings for the network
communication are defined/ displayed in
this menu.
Network Status
Status display of:
• Connection
• IP Address
• Subnet mask
• Gateway IP
WLAN status
(deactivated if LAN used)
Status display of:
• WiFi Signal
• WiFi Channel
• Encryption
IP Settings
Here you can choose whether you want
to assign a fixed IP address or whether
the S119/S120 will obtain an automatic IP
address from the router using DHCP.
Factory setting = DHCP
Selection options:
• Automatic (DHCP)
• Manual input
In the case of a manual input, you can
make the following settings:
o
IP Address
o
Subnet mask
o
Gateway IP
o
DNS Server 1
o
DNS Server 2
Pressing the OK button moves you from
one input field to the next. After the DNS
Server 2 input has been made, the data
is applied and the system attempts to
establish a connection.
WLAN Settings
Here, you can make the settings for a
WLAN connection. If there is no LAN
connection, any wireless networks that
are found, are displayed in a list. Select
the WLAN network you want to use and
allow the system to guide you through
the connection menu.
If there is already a LAN connection, you
can enter the network name (SSID) and
establish a connection by inputting the
password, the encryption type and the
DHCP definitions.
Network Restart
Carry out a restart after modifying the
network settings (IP/ WLAN) or when
swapping the LAN/WLAN network.
Configuration
30