Arctic Cat 2010 Crossfire 600 Operator's Manual page 12

Coolant Temperature
Warning Icon
If the coolant temperature is at or
above the maximum running tempera-
ture, the coolant temperature warning
icon will flash a warning (alert). If the
coolant temperature is at or above the
maximum running temperature, the
coolant temperature warning icon will
cease flashing and will remain con-
stantly illuminated.
Steady Flash
(Coolant Tempera-
ture Icon)
Constant On
(Coolant Tempera-
ture Icon)
CAUTION
At this point, take precautionary
measures such as changing to
loose snow terrain, shutting the
engine off (allowing the engine to
cool down), and checking coolant
level. If unable to either determine
or remedy the problem, take the
snowmobile to an authorized Arc-
tic Cat Snowmobile dealer for ser-
vice. If not under warranty, this
service is at the discretion and
expense of the snowmobile owner.
Low Oil Warning Icon
The Low Oil Warning Icon is designed
to alert the snowmobile operator when
the oil in the oil injection reservoir gets
below a prescribed level; however, it is
highly recommended that a visual veri-
fication of the oil level in the reservoir
be done prior to operating the snowmo-
bile. Once the Low Oil Warning Icon
illuminates during operation of the
snowmobile, the operator must periodi-
cally monitor the level of oil in the res-
ervoir and must fill the reservoir the
next time gasoline is added to the gas
tank. The "alert level" of the Low Oil
Warning Icon is approximately equal to
1 tankful of gasoline under normal
operating conditions.
8
Coolant Temperature
Above 80° C (176° F).
Coolant Temperature
Above 93° C (200° F).
Indicator Icons
(Deluxe Gauge)
Certain models are equipped with a
deluxe gauge combination speedometer/
tachometer. Indicator icons are incorpo-
rated within the speedometer/tachometer.
Also incorporated into the speedometer/
tachometer is a digital readout screen.
A. High Beam
B. Oil Pressure/Low Oil
C. Coolant Temperature
D. Increment Button
E. Select Button
F. Decrement Button
G. Service
RPM/MPH (kph)
By pushing the increment button once,
the RPM and MPH will be displayed
(one on the readout screen and one
with the needle). By pushing the button
once again, the functions will be
reversed.
By pushing the increment button (with
speed being displayed) for more than
two seconds, the display will change
between standard mph or metric kph.
With RPM displayed on the readout
screen by pushing and holding the
increment button, maximum RPM will
be displayed on the readout screen. The
maximum RPM readout will reset
when the decrement button is pushed
(while maximum RPM is displayed).
GENERAL INFORMATION
FZ001E