Tool Kit; Rear Mudguard Extension - APRILIA LEONARDO 125 Use And Maintenance Book

TOOL KIT

The tool kit (1) is fixed under the saddle, inside
the crash helmet/glove compartment.
To reach it:
◆
Raise the saddle,
( U N L O C K I N G / L O C K I N G T H E
SADDLE).
The tool kit includes:
√ 4 mm hexagon spanner;
! "
√ 1 6 m m s p a r k p l u g s o c k e t
spanner;
#
√ 18 mm spark plug socket
300
spanner;
√ socket spanner rod;
√ 8/10 mm socket spanner;
√ double-ended, cross-/cut-headed
screwdriver;
√ square pin spanner;
√ tool case.

REAR MUDGUARD EXTENSION

The rear mudguard extension (2) is
provided as standard equipment and can
be installed if the vehicle is used on wet
roads, since it reduces the reach of the
see p. 22
water spray caused by the rear wheel.
NOTE
rear mudguard extension (2) already
installed in the countries where this is
required for the homologation.
F o r t h e i n s t a l l a t i o n o f t h e r e a r
m u d g u a r d e x t e n s i o n , p r o c e e d a s
follows:
◆
Raise the saddle, see p. 22 (UNLOCKING /
LOCKING THE SADDLE).
◆
Take the rear mudguard extension (2)
o u t o f t h e c r a s h h e l m e t / g l o v e
compartment together with the screws
and relevant nuts provided for the
fastening.
The vehicle is supplied with the
◆
Unscrew and remove the nuts (3).
◆
Remove the reflector (4).
◆
Unscrew and remove the nut (5).
◆
Withdraw the screw (6).
◆
Position the rear mudguard extension (2)
inside the number plate holder support
(7).
◆
Position the reflector (4) and tighten the
relevant nuts (3).
◆
Insert the screw (6) and tighten the
relevant nut (5).
◆
Make sure that the rear mudguard
extension (2) is positioned correctly.
use and maintenance Leonardo 125 - 150 - 250 - 300
23