MOTO GUZZI Griso Workshop Manual page 124

Griso V1100
– damper rod.
Change any component that is badly worn or damaged.
WARNING
Remove any impurities from the bushing; pay
attention not to damage the surface.
When reassembling, replace the following components with
new ones:
– gasket;
– dust seal gasket;
– the two O-rings on the regulator.
Oil quantity: 520 ± 2.5 cu cm (31.7 ± 0.15 cu in).
Oil level: 118 ± 2 mm (4.6 ± 0.079 in) (from sleeve edge).
NOTE To correctly measure the oil level the sleeve must be
perfectly vertical. The oil level must be the same on both
legs.
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
CHASSIS
6 - 31