ZyXEL Communications Prestige 660R-6 Series Read Me First page 5

PROBLEM
The PWR and/or SYS LEDs
are off.
The LAN LED won't turn on.
The DSL LED is off.
I cannot access the SMT
menu.
I cannot access the web
configurator.
I cannot ping any computer
on the LAN.
I cannot access the Internet.
T r o u b
T r o u b
Make sure the Prestige's power adaptor is connected to the Prestige and plugged into an
appropriate power source. Check that the Prestige and the power source are both turned on.
Turn the Prestige off and on. If the error persists, you may have a hardware problem. In this
case, you should contact your vendor.
Check the cable connection to the Prestige LAN port.
Make sure your computer network card is working properly.
Check the connection between the Prestige DSL port and the wall jack.
The default SMT password is "1234". If you have changed the password and have now
forgotten it, you will need to reset the Prestige or upload the default configuration file (see
User's Guide).
Check that your computer IP address and the Prestige IP address are on the same subnet.
If you changed the Prestige default LAN IP address then enter the new one as the URL.
Make sure you enter the correct user name and password. The default user name is "admin"
and the default password is "1234". If you forgot your password, you have to reset the
Prestige. See the User's Guide.
If the 10/100M LAN LED is off, check the cables between the Prestige and your computer or
hub.
Check the TCP/IP configuration on your computer. Make sure that the IP address and the
subnet mask of the Prestige and the computers are on the same subnet.
Make sure the Prestige is turned on and connected to the network.
If the Prestige's DSL LED is off, check the cable between the Prestige and the telephone wall
jack.
Make sure you entered your user name correctly. Your user name may be case-sensitive.
l e s h o o t i n g
l e s h o o t i n g
CORRECTIVE ACTION