Voltage Measurement; Camera Frequency Measurement; Returning Camera Settings - Teledyne HS-40-04k40 User Manual

76

4.7.4 Voltage Measurement

The com m and
m easu rem ent featu re of the cam era provid es only approxim ate resu lts (typically w ithin
10%). The m easu rem ent shou ld not be u sed to set the applied voltage to the cam era bu t
only u sed as a test to isolate gross problem s w ith the su pply voltage.

4.7.5 Camera Frequency Measurement

Purpose:
Syntax:
Syntax Elem ents:
Exam ple:

4.7.6 Returning Camera Settings

Returning All Camera Settings with the Camera
Parameter Screen
The cam era param eter (
below d escribes the
To read all current camera settings, use the command:
Syntax:
Figure 35: Example GCP Screen for HS-40-04k40 TDI Mode Operation
GCP Screen
C A M E R A
Camera Model No.:
Sensor Serial No.:
Firmware Design Rev.:
CCI Version:
FPGA Version:
UART Baud Rate:
03-032-20013-04
vv d isplays the cam era's inpu t voltage. N ote that the voltage
Returns the frequency for the requested Cam era Link control
signal
gsf i
i
Cam era Link control signal to m easure:
1: CC1 (EXSYN C)
2: CC2 (Spare)
3: CC3 (Forw ard )
4: CC4 (Spare)
gsf 1
) screen retu rns all of the cam era's cu rrent settings. Figu re 35
gcp
gcp
screen for the Piranha H S-8k cam era.
gcp
S E T T I N G S
HS-xx-xxxxx-xx-R
xxxxxxxxx
xx-xx-xxxxx-xx
xx-xxx-xxxxx-xx
xx-xx-xxxx-xx
9600
Piranha HS-xx RoHS User Manual
Description
Cam era m od el num ber.
Sensor serial num ber.
Firm w are d esign revision
num ber.
Cam era control
inform ation.
DSP d esign revision
num ber.
Serial com m unication
connection speed set w ith
the sbr com m and . See
section Setting Baud Rate
for d etails.
Teledyne DALSA