Aquapalm Transceiver J-Box Installation; Aquapalm Handheld Remote Installation - Jandy AquaPalm Installation And Operation Manual

Wireless handheld remote (for use with aqualink rs onetouch and all button systems)
Table of Contents

Advertisement

Low Voltage
Raceway
Conduit Knockout for Low Voltage
AquaPalm J-box Wire
Heyco Fittings for
Low Voltage JVA
and Sensor Wires
Figure 3.
AquaPalm J-Box Cable Connection to
Power Center PCB
3.2

AquaPalm Transceiver J-box Installation

Installation Considerations. The transceivers will
transmit through walls and around corners. Steel
framing, aluminum siding, wrought iron, cyclone
fences, leaded glass, and other 900 MHz frequency
items may inhibit/prevent communication between
the AquaLink RS AquaPalm Handheld Remote
and the Power Center. The transceivers do not
require line of sight to communicate. To optimize
communication, install transceivers in a location that
minimizes interference.
1.
Turn off all power to the Power Center.
2.
Mount the Outdoor Transceiver J-box at least
6' above the ground and at least 8' from any
air blowers that may be in the vicinity (see
Figure 4).
High Voltage
Knockouts for
Conduit
(DO NOT run any Low
Voltage wires through
these knockouts)
AquaPalm
Transceiver
J-box
6'
Ground
Level
Figure 4.
Outdoor Transceiver J-box Installation
3.
The Transceiver J-box antenna must point
towards the sky.
NOTE To improve performance of the transceiver, mount
the J-box more than 6' above the ground.
4.
Open the door to the Power Center and
remove the dead panel.
5.
Feed the four conductor wire into the Power
Center through the low voltage raceway.
6.
Cut off the excess wire. Strip the jacket back 6"
and strip the individual wires approximately
¼". Connect the four conductor wire to the
red terminal bar on the Power Center PCB.
7.
Install the dead panel to the Power Center and
restore all power.
3.3

AquaPalm Handheld Remote Installation

1.
Remove the Handheld Remote from the
packaging.
2.
On the back of the Handheld Remote, loosen
and remove the two (2) screws that secure
the cover for the battery chamber (see
Figure 5).
3.
Install two (2) AA batteries. Ensure that the
polarity is correct.
Page 7
Air
Blower
Minimum 8'
Low Voltage Raceway
Power
Center
Red 4-Pin
Terminal Bar

Advertisement

Table of Contents
loading

Table of Contents