Set Temperature Menu; Set Time Menu; Aquapure Menu - Jandy AquaPalm Installation And Operation Manual

Page 14
5.9

Set Temperature Menu

MENU > SET TEMP > POOL or SPA > SET TEMP VALUE
The SET TEMP menu allows you to preset the pool
and spa thermostats.
NOTE For pool/spa combination systems, the default
pool temperature is 80°F and the default spa
temperature is 102°F. For pool only/spa only
systems, the default TEMP1 temperature is 80°F
and the default TEMP2 temperature is 60°F.
MAIN MENU
SET TEMP
SET TIME
PALM OPTIONS
back
select
1 2
SET TEMP
POOL HEAT 80°F
SPA HEAT 104°F
Highlight an
item and press
SELECT
back
select
1 2
Figure 20. Set Temperature Menu
To set Pool/Spa Temperatures
Highlight MENU and press SELECT, highlight
SET TEMP and press SELECT. Inside the SET
TEMP menu, use the UP/DOWN arrow keys to
highlight either POOL (TEMP1) or SPA (TEMP2)
and press SELECT. Use the UP/DOWN arrow keys
to increase or decrease the temperature and press
SELECT to apply the setting.
5.10

Set Time Menu

MENU > SET TIME
The SET TIME menu allows the correct time and date
to be entered. The correct time and date ensures that
programming will work properly.
SET TEMP
POOL HEAT 80°F
SPA HEAT 104°F
Highlight an
item and press
SELECT
back
select
1 2
SET TEMP
POOL HEAT 85°F
SPA HEAT 104°F
Highlight an
item and press
SELECT
back
select
1 2
NOTE A nine volt (9 V) battery is located at the Power
Center that allows the system clock to continue to
run during power outages. Ensure that the battery
is checked or replaced annually.
MAIN MENU
SET TEMP
SET TIME
PALM OPTIONS
back
select
1 2
Figure 21. Set Time Menu
To set the Time
Highlight MENU and press SELECT, highlight
SET TIME and press SELECT. Use the UP/DOWN
arrow keys to set values. Press the SELECT button
to continue.
5.11

AquaPure Menu

MENU > SET AQUAPURE > SET OUTPUT%
NOTE This equipment may not be part of your system.
Please check with your installer.
AquaPure Chlorine Generator system exclusively
communicates with the AquaLink RS. The AquaPalm
Handheld Remote will display % of chlorine
output.
This menu item will only appear when an AquaPure
chlorine generator is connected to the AquaLink RS
system by means of the red 4-pin terminal bar.
To set the AquaPure Output Percentage (%)
Highlight MENU and press SELECT, highlight SET
AQUAPURE and press SELECT. Use the UP/DOWN
arrow keys to change the percentage.
See Section 5.14 for BOOST options.
NOTE When the Chlorine Generator output percentage
is set to a value greater than 0 and the filter
pump is on, the system salinity level and output
percentage appears on the equipment status
screen.
SET TIME
10/10/05 MON
10:00 AM
Use ARROW KEYS
to set value.
Press SELECT
to continue.
back
select
1 2