Table of Contents
Advertisement
Installation and Operation Data
Installation and
Operation Manual
AquaPalm
Wireless Handheld Remote
(For use with AquaLink
OneTouch and All Button Systems)
FOR YOUR SAFETY - This product must be installed and serviced by a professional pool/spa service
technician. The procedures in this manual must be followed exactly. Failure to follow warning notices
and instructions may result in property damage, serious injury, or death.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an electrical source on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Modifications made to this equipment, which are not authorized by the manufacturer, may void the user's authority
to operate this equipment.
RS
®
WARNING
ATTENTION
Advertisement
Table of Contents
Related Manuals for Jandy AquaPalm
Summary of Contents for Jandy AquaPalm
- Page 1 Installation and Operation Data Installation and Operation Manual AquaPalm Wireless Handheld Remote (For use with AquaLink ® OneTouch and All Button Systems) WARNING FOR YOUR SAFETY - This product must be installed and serviced by a professional pool/spa service technician. The procedures in this manual must be followed exactly. Failure to follow warning notices and instructions may result in property damage, serious injury, or death.
-
Page 3: Table Of Contents
Page 3 Table of Contents Section 5. AquaPalm Handheld Remote Menus Section 1. Important Safety Instructions ... 5.1 Pool Mode/Spa Mode ..... Section 2. Product Description ......5.2 Equipment On/Off Menu ....2.1 Basic Functions ......5.3 Filter Pump (Pool Mode) .... -
Page 4: Section 1. Important Safety Instructions
Page 4 Section 1. Important Safety Instructions READ AND FOLLOW ALL INSTRUCTIONS LIRE LA NOTICE TECHNIQUE. All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes. When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: DANGER To reduce the risk of injury, do not remove the suction fittings of your spa or hot tub. - Page 5 Page 5 WARNING People with infectious diseases should not use a spa or hot tub. To avoid injury, exercise care when entering or exiting the spa or hot tub. Do not use drugs or alcohol before or during the use of a spa or hot tub to avoid unconsciousness and possible drowning.
-
Page 6: Section 2. Product Description
6" 1" 1" Basic Functions Side View (at Angle) The AquaPalm Handheld Remote can be used in addition to an already existing AquaLink RS control Front View Side View (at Angle) system. The AquaPalm can turn your pool/spa equipment on and off in one of the following ways: Figure 2. -
Page 7: Aquapalm Transceiver J-Box Installation
900 MHz frequency restore all power. items may inhibit/prevent communication between the AquaLink RS AquaPalm Handheld Remote AquaPalm Handheld Remote Installation and the Power Center. The transceivers do not require line of sight to communicate. To optimize... -
Page 8: Changing The Frequency Channel
To prevent unwanted operation the channel back select for your AquaLink RS AquaPalm system can be changed. The AquaPalm Handheld Remote and the AquaPalm Transceiver J-box must be set to the same RF channel. DOWN SELECT Button Button At the Transceiver J-box, remove the cover to expose the PCB (see Figure 6). -
Page 9: Section 4. Aquapalm Handheld Remote Operation
Power Item Basic Functions ON/Off Hotkeys Use the AquaPalm Handheld Remote to turn your 1 and 2 pool/spa equipment on and off in one of the following ways: Activate the main equipment on the front screen by highlighting the selection, then Figure 10. -
Page 10: Battery Status
POOL MODE POOL MODE POOL HEATER POOL HEATER SPA MODE SPA MODE The AquaPalm Handheld Remote uses two (2) AA SPA HEATER SPA HEATER MENU MENU EQUIPMENT ON/OFF EQUIPMENT ON/OFF batteries. The batteries are located behind the cover on the back side of the Handheld Remote. -
Page 11: Filter Pump (Pool Mode)
Page 11 Filter Pump (Pool Mode) EQUIPMENT ON/OFF > FILTER PUMP FRI 10:30 PM EQUIPMENT POOL FILTER PUMP 80° 78° POOL HEAT POOL MODE SPA HEAT POOL HEATER The FILTER PUMP selection turns the main filtration SOLAR HEAT SPA MODE AUX 1 SPA HEATER AUX 2... -
Page 12: Pool Heat
Page 12 Pool Heat Spa Heat EQUIPMENT ON/OFF > FILTER PUMP > POOL HEAT > EQUIPMENT ON/OFF > SPA > SPA HEAT > (Set to Desired Temperature) (Set to Desired Temperature) The SPA HEAT enables the heater for the spa. The The POOL HEAT selection enables the heater for the desired temperature can be set from the SET TEMP pool. -
Page 13: Solar Heat
Page 13 Solar Heat EQUIPMENT ON/OFF > SOLAR HEAT EQUIPMENT FILTER PUMP POOL HEAT The SOLAR HEAT selection controls solar heating. SPA HEAT AUX 1 AUX 2 A solar heating system and optional solar sensor are AUX 3 EXTRA AUX MORE required for SOLAR HEAT selection to operate and must be part of the normal circulation system. -
Page 14: Set Temperature Menu
NOTE This equipment may not be part of your system. Please check with your installer. Figure 20. Set Temperature Menu AquaPure Chlorine Generator system exclusively communicates with the AquaLink RS. The AquaPalm To set Pool/Spa Temperatures Handheld Remote will display % of chlorine output. -
Page 15: Auto Shut-Off Menu
Choose setting and press SELECT. minute auto shut off. The display can be re-enabled by pressing the Power ON/OFF button. back select NOTE AquaPalm default is set to two (2) minutes. MAIN MENU PALM OPTIONS SET TEMP SET AUTO-OFF SET TIME... -
Page 16: Boost Menu
BOOST POOL SET TEMP TIME REMAINING SET TIME SET AQUAPURE 24:00 PALM OPTIONS PAUSE RESTART Figure 25. AquaPalm Options Menu - Assign STOP BOOST POOL Hotkeys back back select select To change the Hotkeys setting Highlight MENU and press SELECT. Highlight PALM OPTIONS and press SELECT. -
Page 17: Aquapalm Handheld Remote Menu Flow Chart
Page 17 5.17 AquaPalm Handheld Remote Menu Flow Chart POOL MODE POOL HEATER SPA MODE SPA HEATER SELECT EQUIPMENT EQUIPMENT ON/OFF ALL OFF DEVICES ONETOUCH 1 HOTKEY 1 & 2 ONETOUCH 2 ONETOUCH 3 SET MONTH, DAY, SET TIME YEAR & TIME... -
Page 18: Section 6. Troubleshooting
2. Wrong PPD. 2. Make sure that the PPD is for an AquaPalm. not operate at all. 3. Damaged power center PCB. 3. If PPD is installed correctly, replace the power center PCB. - Page 19 Page 19 NOTES...
- Page 20 DE grids, or cartridge elements; or damage caused by running the pump with insufficient quantities of water. LIMITATION OF LIABILITY: This is the only warranty given by Jandy Pool Products, Inc. No one is authorized to make any other warranties on behalf of Jandy Pool Products, Inc. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY.