Table of Contents
Advertisement
3
Installing your appliance
3.1 Electric connection
The appliance has been manufactured as a
•
class II, therefore no earth cable is necessary.
The electrical connection point must be easily
accessible after the installation of the appli-
ance. A suitably dimensioned omnipolar switch
with 3 mm minimum opening between contacts
must be fitted between the appliance and the
electricity supply in compliance with the load
and current regulations.
The connection to the mains is carried out as
•
follows:
BROWN = L line
BLUE = N neutral.
Cooker Hood / User Manual
This device must be hardwired to the mains
•
supply network by connecting to a single phase
spur protected by a 3A fuse.
The minimum distance between the support
•
surfaces of the cooking pots on the cooker top
and the lowest part of the cooker hood must be
at least 65 cm. If a connection tube composed
of two parts is used, the upper part must be
placed outside the lower part. Do not connect
the cooker hood exhaust to the same conductor
used to circulate hot air or for evacuating fumes
from other appliances generated by other than
an electrical source. Before proceeding with the
assembly operations, remove the anti-grease
filter(s) (Fig.4) so that the unit is easier to han-
dle.
9 / 14 EN
Advertisement
Table of Contents
