Lighting - Beko CTB 6254 X User Manual

4 Operating your appliance
Commands luminous (Fig.11) the key symbols
are explained below:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes (*)
If your appliance has the INTENSIVE speed func-
tion, from speed THREE, press key E for 2 sec-
onds and it will be activated for 10 minutes after
which it will return to the previously set speed.
When the function is active the LED flashes. To
interrupt it before the 10 minutes have elapsed,
press key E again. Some models allow activating
this function even with speed one and two.
By pressing key F for two seconds (with the hood
switched off) the "clean air" function is acti-
vated. This function switches the appliance on for
ten minutes every hour at the first speed. As soon
as this function is activated the motor starts up at
the first speed for ten minutes. During this time
key F and key C must flash at the same time.
After ten minutes the motor switches off and the
LED of key F remains switched on with a fixed
light until the motor starts up again at the first
speed after fifty minutes and keys F and C start to
flash again for ten minutes and so on. By press-
ing any key for the exclusion of the hood light the
hood will return immediately to its normal func-
tioning (e.g. if key D is pressed the "clean air"
function is deactivated and the motor moves to
the 2nd speed straight away. By pressing key B
the function is deactivated).
(*) The "AUTOMATIC STOP TIMER" delays
stopping of the hood, which will continue func-
tioning for 15 minutes at the operating speed set
at the time this function is activated.
Cooker Hood / User Manual
Anti-grease/active charcoal filters
saturation:
When the A key flashes with a 2 second fre-
•
quency the anti-grease filters must be washed.
When the A key flashes with a 0.5 second
•
frequency the active carbon filters must be
replaced or washed depending on the type of
filter.
Once the clean filter has been put back one must
reset the electronic memory by pressing the A
key for approximately 5 seconds until it stops
flashing.

4.2 Lighting

Light Replacement
28W light
• Remove the metal grease filters.
• Unscrew the bulbs and replace them with new ones
having the same characteristics.
• Replace the metal grease filters.
13 / 14 EN