Disassembly Of The Microphone; Technical Specifications - Marek Design RS1 Owner's Manual

Tube condenser mic
Table of Contents

Advertisement

Available languages

Available languages

The RS1 is recommended for use by experienced users!
Note: this equipment works with lethal currents!
Keep away from children!
Do not operate in damp or wet areas!
Please read the operating instructions completely before start-up!

6. Disassembly of the microphone

Opening and disassembling the microphone as well as the control-unit is to be done only by one
of our authorized technicians. The microphone could be irreversibly damaged!!!
Opening the screw connections sealed by the factory will void all warranties!

7. Technical specifications

Acoustical operating principle ......................................... Pressure/ Pressure gradient transducer 3)
Directional pattern ....................................... Omni, wide angle cardioid, cardioid, hyper-cardioid,
figure-8 and corresponding intermediate patterns 3)
Frequency response.............................................................................................. 10 Hz - 25 kHz 3)
Sensitivity 1) at1 kHz /1 Pa ........................... 119mV/Pa (-18,5dBV ) to 653mV/Pa (-3,7dBV) 3)
Nominal impedance.......................................................................................................... 200 Ohm
Nominal load impedance ................................................................................................ 1000 Ohm
S/N ratio CCIR 468-3 Peak ............................................................................. 82,5dB to 67,7dB 3)
S/N ratio DIN/IEC 651 .............................................................................. 92,5dBA to 77,7dBA 3)
Equivalent SPL CCIR 468-3 Peak ................................................................... 11,5dB to 26,3dB 3)
Equivalent SPL DIN/IEC 651 ...................................................................... 1,5dBA to 16,3dBA 3)
Maximum SPL at 1 kHz 2)......................................................................... 143,3 dB to 126,5 dB 3)
with 27 dB attenuation ............................................................................... 170,3 dB to 153,5 dB 3)
Maximum output voltage .................................................................................................. +31 dBV
Dynamic range .............................................................................................................. 127dB SPL
Extended dynamic range ............................................................................................... 154 dB SPL
6

Advertisement

Chapters

Table of Contents
loading

Table of Contents