Figure 3-11 Hand Signals - Axis A20 Manual

Operation
Communication between the skier and driver is essential. Standard signals have been
developed by the American Waterski Association and have been accepted by most
waterskiers. Once the skier is in the water and ready, the driver of the boat will take the
slack out of the tow line. When the skier is in position and prepared for lift, the skier
shouts "hit it" which is the signal for the driver to open the throttle for take-off. Once the
skier is on plane, there are a number of hand signals that will allow communication
between the skier and the driver of the boat. A copy of these signals can be found for
review at your local Axis dealership or by contacting the American Waterski Association
at (813) 324-4341.
CIRCLE
TURN LEFT
TURN RIGHT
Figure 3-11. Hand Signals
Once a skier has fallen or is ready to quit skiing, the driver must be prepared for
immediate removal of the skier from the water. The driver of the boat should keep the
skier in line of sight as much as possible until the skier is reached. Once the boat is up to
the skier, the driver should always turn off the engine until the skier is onboard. There
should be no exception to this rule as there is always the possibility of the skier slipping
or falling back into the water risking contact with the boat propeller.
BACK
TO DOCK
SKIER IN WATER
WATER SPORT HAND SIGNALS
CUT ENGINE
SKIERS O.K.
SPEED FASTER
SPEED SLOWER
SPEED OK
STOP
KC-0016C-A
3-15