❿ Using The Stylus Pen (Calibration); Automatic Calibration; Manual Calibration - NEC UM352W User Manual

❿ Using the stylus pen (Calibration)
Either when using the stylus pen for the first time or changing the installation place of the projector, make sure to
perform calibration for letting the projector to recognize the stylus pen position properly.
There are three options for the pen set up.
AUTO CALIBRATION

MANUAL CALIBRATION

REMOTE PEN
After performing calibration of the stylus pen, you can use the stylus pen on the WHITEBOARD, etc. in the APPS MENU.
TIP:
• On the [PEN SETTINGS], you can also perform the adjustment of the separately sold Touch Module also. About the information
for adjustment, refer the manual uploaded on our web site.

Automatic Calibration

1. Press APPS button on the remote.
The APPS MENU is displayed on.
2. Select [TOOL] → [PEN SETTINGS]
The [PEN SETTINGS] screen is displayed on.
3. Set the focus on the [AUTO CALIBRATION] and then press ENTER button.
Start calibration.
Position adjustment will be completed within 5 to 8 seconds and the message of the calibration completion will be
displayed on.
Manual Calibration
1. Set the focus on the [MANUAL CALIBRATION] in the [PEN SETTINGS] and press ENTER.
The projection screen will switch to the manual calibration screen and a red dot will be indicated at the left top of
the screen.
2. Touch the center of dot by the stylus pen.
• After touching the red dot, it moves to 25 positions in order.
3. Touch all 25 positions.
Complete the position adjustment and the message of calibration completion will be displayed on.
NOTE:
• You may not able to perform manual calibration by the affection of the light from outside.
Adjust the stylus pen position automatically. Select this for easy adjustment.
Adjust the stylus pen position manually. Select this for precise position adjustment
as for permanent projector installation.
Operation by a computer mouse can be performed by the stylus pen touch.
For utilizing the remote pen, connect the USB-B port on the projector and the USB-A
port on the computer by the supplied USB cable.
NOTE:
• Before starting to use the remote pen, install the latest IWB Setup Software for the white
board kit onto the computer and perform calibration. The latest IWB Setup Software for
the white board kit is available to download from our web site:
http://www.nec-display.com/dl/en/pj_soft/lineup.html
42
3. Convenient Features