Putting It All Together - AMX PT10-ADD Instruction Manual

Installation and Wiring
2-pin power connector
AXB-PT10
AXlink connector
2-pin power connector
FIG. 12 AXlink connector split cable wiring diagram

Putting It All Together

1. Connect the green 2-pin PS2.8 power connector to the rear of the AXB-EM232.
2. Connect the AXB-PT10 AXlink connectors (from the AXB-EM232) to the AXlink port on the
side of the AXB-PT10.
3. Connect the CC-AXL 2-pin power connector to rear of the PSN6.5 power supply.
When applying power to the AXB-PT10, adjust the soft-set pan/tilt-limit stops to a safe position to
prevent camera or AXB-PT10 damage.
4. Connect the lens control cable to the LENS connector (6-pin) on the rear of the camera.
5. Connect the DB-9 port on the AXB-PT10 to the 8-pin mini-DIN REMOTE connector on the
rear of the camera (for systems where the camera is located within 25 m of the CMA-D2).
For systems where the camera is located over 25 m, use the 4-pin captive-wire to mini 8-pin
DIN cable to connect the CMA-D3 to the AXB-EM232 (RS-232 port 1 on the rear panel of the
AXB-EM232). The CMA-D3 can be located up to 100 m from the camera.
6. Use a BNC cable to connect the VIDEO OUT port on the rear of the camera to the BNC
connector on the rear of the AXP-PLV.
7. Connect the CMA-D2 to the DC IN/VBS port on the rear of the camera.
8. Verify there are no obstructions in the horizontal or vertical paths of the attached camera on the
AXB-PT10.
9. Connect the mini-XLR connector (from the AXB-EM232 AXlink connector) to the rear of the
AXP-PLV.
For best performance. mount the AXB-EM232 as close to the CMA-D2 as possible.
12
PWR+
to PSN6.5
GND-
PWR+
AXP
AXM
GND-
PWR+
to PSN6.5 GND-
PWR+
AXP
AXM
GND-
AXB-PT10
AXlink connector
AXB-EM232
AXlink connector
PT10-ADD Additional Camera Pan/Tilt System
PWR+
AXP
AXM
GND-