Mounting And Balancing The Camera/Lens - AMX PT10-ADD Instruction Manual

Installation and Wiring
FIG. 3 Center position for the camera cradle attachment (side view)
bolts and lock washers. Ensure that the external white position marker, on the pan drive hub, is
inside the desired camera rotation range.
(on the outer surface)
3.453" (87.7 mm)
FIG. 4 Mounting-plate dimensions
The PT10 can be mounted to camera mounts such as the TM-CAM, WM-CAM, and PM-CAM
(Pedestal mount) as shown in FIG. 5. The Camera/Lens cradle can be mounted on either side of the
cradle support bracket.

Mounting and Balancing the Camera/Lens

The camera/lens assembly should be mounted so that the tilt axis is capable of going through the
optical axis of the camera, assuming the optical centerline is between ½" (12.70 mm) and 5"
(127.00 mm) above the mounting plane of the camera lens. The mounting platform (camera mount)
allows the camera/lens to be mounted with its center of gravity on the tilt axis. The maximum
weight of the camera/lens assembly is 10 lbs. (4.54 kg). The camera cradle is mounted to the Tilt
Hub. See FIG. 6 for dimensions.
6
Camera points this way when the pan drive is in the center
of it's range of motion (Home position).
Position marker
3.00" BHC
(76.20mm)
Tilt Hub
Central tilt-axis
Camera cradle mounting holes
Camera points this way
Position markers, located on the outer surfaces, mark
the center for the vertical range of camera motion.
Pan Hub (mounting-plate)
3.45"
(87.7 mm)
PT10-ADD Additional Camera Pan/Tilt System
.