Table of Contents
Advertisement
Wire
tie-mount
FIG. 5 PT10 and pedestal mount
0.75"
(19.05 mm)
0.25"
(6.35 mm)
0.25"
(6.35 mm)
0.75"
(19.05 mm)
FIG. 6 Tilt Hub dimensions
To mount and balance the camera/lens:
Do not lift the PT10 by the Camera/Lens cradle as this procedure damages internal components.
1. Remove the camera/lens cradle assembly by removing the four ½" screws and washers from
the Tilt Hub.
2. Separate the camera mount and cradle support bracket by removing the two ½" screws on the
underside of the assembly (FIG. 7) using a 3/32 Allen wrench.
3. Install the camera alignment peg to the mount at the position that best fits the camera/lens.
4. Secure the camera/lens to the cradle (at the camera alignment peg) with the screw and fastener
supplied with the camera/lens (see FIG. 7).
PT10-ADD Additional Camera Pan/Tilt System
0.75"
(19.05 mm)
0.00"
0.75"
(19.05 mm)
Camera points in
this direction
0.56" (39.62 mm)
Installation and Wiring
Cradle support bracket
Camera mount assembly
Pedestal mount
7
Advertisement
Table of Contents
