Table of Contents
Advertisement
Installation and Wiring
Camera mount
(underside view)
FIG. 7 Camera/Lens cradle assembly (camera mount and lens mount)
5. Determine (and note) the center of gravity for the camera by using your finger to balance the
entire camera/lens and mount. The center of gravity is the location on the long axis of the
camera/lens assembly around which the camera balances.
6. Place the camera/mount in the appropriate location along the cradle support bracket so the
camera's center of gravity aligns with the horizontal tilt-axis, as shown in FIG. 8.
Camera/lens
and mount
FIG. 8 Mounting a camera
Mount the camera as close to the Tilt Hub as possible to obtain a true center of gravity.
7. Re-attach the camera mount (camera/lens) to the cradle support bracket using the two ½"
screws.
8. Take the entire camera/cradle assembly and align the lens with the Tilt Hub, so the vertical-axis
intersects the center of the camera's iris, as shown in FIG. 9.
8
Mounting holes (three sets)
Center of gravity (approximate)
PT10-ADD Additional Camera Pan/Tilt System
Cradle support bracket
Camera/Lens cradle
assembly (side view)
Camera alignment peg
Horizontal
tilt-axis
Advertisement
Table of Contents
